News: Trouble logging in? Log in from the login page.
June 17, 2019, 08:11:41 pm

Author Topic: replacing XLR output with rca  (Read 105 times)

0 Members and 1 Guest are viewing this topic.

Offline Deke609

  • Sr. Member
  • ****
  • Posts: 373
replacing XLR output with rca
« on: June 02, 2019, 10:39:42 am »
If I replace the xlr output connectors with rca, am I correct that I can/should remove all of the following for each output: the 10uF cap and the two resistors (475K and 604)?

And then just connect existing red/black center pins to new respective red/black center pins, and existing ground tabs to respective new ground tabs?

I think this is right, but want someone who understands these things better than me to confirm.

Many thanks,

Derek



« Last Edit: June 02, 2019, 10:41:42 am by Deke609 »
Derek
______

Roon Intel NUC ->  Yggdrasil DAC -> BeePre (w/ BeeQuiet and JJs)  -> Stereomour IIs (2A3 and 45 Conversion - both fully upgraded)  -> Audeze LCD4

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 10815
Re: replacing XLR output with rca
« Reply #1 on: June 02, 2019, 10:48:00 am »
Yes.  You could also just plug an RCA splitter into the RCA output jacks, or an XLR to phono adapter into the XLR jacks.
Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Deke609

  • Sr. Member
  • ****
  • Posts: 373
Re: replacing XLR output with rca
« Reply #2 on: June 02, 2019, 11:16:29 am »
Many thanks PB.
Derek
______

Roon Intel NUC ->  Yggdrasil DAC -> BeePre (w/ BeeQuiet and JJs)  -> Stereomour IIs (2A3 and 45 Conversion - both fully upgraded)  -> Audeze LCD4